而螺紋至骨釘尾端之長度設定為7 mm~ 11 mm (L)，螺紋最大徑

而螺紋至骨釘尾端之長度設定為7 mm~ 11 mm (L)，螺紋最大徑為2.0 mm (D)，底徑為1.5 mm，節距為0.65 mm、頭端圓角半徑為R 0.2 mm (r4)、尾端圓角半徑為R 0.1 mm (r5)、頭端傾角為30度、尾端傾角為17度，如圖4 (b)牙型放大圖所標示。示

Kết quả (Anh) 1:

And thread to bone nail tail end of length set for 7 mm~ 11 mm (l), thread maximum diameter for 2.0 mm (d), end of diameter for 1.5 mm, section from for 0.65 mm, and head end round angle RADIUS for r 0.2 mm (R4), and tail end round angle RADIUS for r 0.1 mm (R5), and head end dip for 30 degrees, and tail end dip for 17 degrees, as Figure 4 (b) teeth type zoom figure by marked. As shown in

Kết quả (Anh) 2:

The length of the thread to the trailing end of the bone nail set to 7 mm ~ 11 mm (L), the maximum thread diameter of 2.0 mm (D), a bottom diameter of 1.5 mm, a pitch of 0.65 mm, the tip radius is R 0.2 mm (r4), the trailing end of the fillet radius R 0.1 mm (r5), the tip angle is 30 degrees, 17 degrees inclination of the tail end, as shown in Figure 4 (b) an enlarged view of the indicated tooth type. Show

Kết quả (Anh) 3:

And thread to the bone nail tail length set to 7 mm ~ 11 mm (L) and maximum thread diameter of 2.0 mm (d), the bottom diameter of 1.5 mm, pitch to 0.65 mm, tip radius r 0.2 mm (R4), end of radius r 0.1 mm (R5), end angle is 30 degrees, end of the angle of 17 degrees, such as Figure 4 (b) tooth type enlargement marked. show