(2)轉入扭力設定:根據ASTM F543-07中的扭力實驗，本模擬為

(2)轉入扭力設定:根據ASTM F543-07中的扭力實驗，本模擬為拘束住骨釘尾端並於骨釘頭端施以下壓力5磅(22.2411 牛頓)，扭力值為180 N‧mm進行扭轉如圖15 (b)。並且進行矯正骨釘模型的受力分析，比較骨釘模型與齒槽骨之總反作用力、最大應力。

Kết quả (Anh) 1:

(2) to the torque setting: torque experiment according to ASTM F543-07, this simulation is bound end of the nail and nail tip application pressure 5 lbs (22.2411 n), reversing the torque value 180 n ‧ mm as shown in Figure 15 (b). Corrective and analyzing model of bone nail, nail modeling and the total reaction of alveolar bone, maximum stress.

Kết quả (Anh) 2:

(2) into the torque setting: according to ASTM F543-07 the torsion test, this simulation is constrained living bone and bone nail nail head end of the end of the following applied pressure of 5 pounds (22.2411 N), torque is 180 N‧mm torsion FIG. 15 (b). Stress analysis and correction pegs model, compare the total reaction force model and alveolar bone pegs, the maximum stress.

Kết quả (Anh) 3:

(2) into the torque setting: torsion experiments according to the ASTM F543-07. The simulation for a constrained live bone nail tail end and in the bone nail head end applied pressure on the following five pounds (22.2411 Newton), the torque values for 180 n, mm twist as shown in Figure 15 (b). And the stress of bone screw model analysis, comparison of bone nail model and alveolar bone of the total reaction force, maximum stress.